Looking at first AR. Any suggestions,

[O d gout]

So yours just dropped in like its suppose to without any mcgyver work? Was is a quad rail or magpul or another unit?

Took me 20 min to put a Magpul Moe forend on my Norc. Very minor dremel work, could have done it in ten with a friends help.

 

[Mr.Sparkle]

So yours just dropped in like its suppose to without any mcgyver work? Was is a quad rail or magpul or another unit?

My MOE's needed a little Dremel work to the handguards (not the CQ-A). I eventually replaced them with a DD Omega 7 free float quad rail. It took about two minutes to install with no issues whatsoever.

 

[igojuone]

A lot of people bash the norc because of either the finish or the fact that its Chinese. I think deep down a lot of people resent the fact that a $700 norc shoots as well as their $2000 gun.

You could be right but if I wanted to support a communist country then I would move there.

 

[PitBull1973]

A lot of people bash the norc because of either the finish or the fact that its Chinese. I think deep down a lot of people resent the fact that a $700 norc shoots as well as their $2000 gun.

Shoots as well , sure after they spent another $1000 plus. That's funny

 

[84wh1]

Wow, my old thread came back from the dead. Doesn't matter anyways, I bought a Tavor instead.

 

[mikethebike]

Wow, my old thread came back from the dead. Doesn't matter anyways, I bought a Tavor instead.

youll wind up keeping the tavor and buying an ar15 in a few months anyway, such is the cycle of life...

 

[TRaTSeRiF]

youll wind up keeping the tavor and buying an ar15 in a few months anyway, such is the cycle of life...

Better to buy one now.. They're being DUMPED on the market

 

[84wh1]

As much as i would like an AR15, my next purchase is going to be a nice bolt action in an MDT chassis. I can plink with a c8 at work any time I want to anyways so no rush on the AR.......unless they go NR! lol