Looking for a Canadian source for bullet molds

I know it's an older thread but MP Molds in Slovenia are fantastic. Pricy but worth it IMHO., I have 4 Brass and one Aluminum mold from them. only went aluminum as they were sold out of the Brass.
 
Helka said:
I know it's an older thread but MP Molds in Slovenia are fantastic. Pricy but worth it IMHO., I have 4 Brass and one Aluminum mold from them. only went aluminum as they were sold out of the Brass.
Click to expand...
Unfortunately they do not seem to be producing too much. I've tried for a few months now to get a couple of their molds and they are always out of stock. Too bad as I have heard good things about them.
 
ted_dent said:
Unfortunately they do not seem to be producing too much. I've tried for a few months now to get a couple of their molds and they are always out of stock. Too bad as I have heard good things about them.
Click to expand...

I know they just got a new lathe to turn their own pins for the HP molds. I'm sure they will be back up in stock in the next 6 months or so.
 
Helka said:
I know it's an older thread but MP Molds in Slovenia are fantastic. Pricy but worth it IMHO., I have 4 Brass and one Aluminum mold from them. only went aluminum as they were sold out of the Brass.
Click to expand...

They're not all fantastic. My ordered .457 in 265gr hb Webley Mk II mold throws .455 on the dot with wheel weights. I contacted Miha who said he calculates with pure lead... because it totally makes sense for an alloy with more tin and better fill out to throw a smaller bullet... I am not the only one with such issues. My future orders for non PP will be from Tom at accurate or NOE who have both been so far.
 
Loyalist said:
Has anyone tried the aluminum molds from Arsenal Molds? I was looking at a couple of the designs and the price seemed great
Click to expand...

I've got a 6 cavity .401 Puckett and a 260 gr .454 Arsenal . I'm happy with them the Puckett seemed to take a bit too break in and throw consistent drops, sorted out in the second casting session. The .454 was decent the first casting session. I'd have no issues buying from them again.
 
Last edited:
I was going to start a thread About Accurate Molds. What do you figure is the best material to make a 2 cavity rifle mold out of? Don't have a ton of experience casting my own. Looking at .40 cal bore to launch a 200- 210 grain bullet with a black powdwer charge. Won't be shooting this rifle on a regular basis, but might take hunting a few times if I can get it in order.
 
ted_dent said:
Unfortunately they do not seem to be producing too much. I've tried for a few months now to get a couple of their molds and they are always out of stock. Too bad as I have heard good things about them.
Click to expand...

They still produce but, selling them thru group buy. mainly thoise group came from castboolist forum. I got one from MP this way ;)
 
I just picked up two more molds another 9mm and a 12 ga one. 25% off right now. They seem to have quite a bit more in stock. They are officially turning their small pins themselves for the HP molds.
 
You must log in or register to reply here.
Back
Top Bottom