looking for dissasembly/assembly instuctions for a voere 30-06

O

okanagancowboy

New member
EE Expired
Rating - 0%
0   0   0
Location
kelowna b.c.
i can't find a schematic for this rifle.the only numbers i can find on the rifle are the serial # and a z567.nothing that says anything about a model #.i have tried stevespages and other schematic site and can't find anything.basically i need to know about the bolt,how it comes apart and goes back together.also i am looking for a decent synthetic stock for the same gun.hope someone can help me out here.

thanx
 
Without seeing it, I would guess that it comes apart much like a 98 Mauser bolt. Pull back on the cocking piece and spin the bolt shroud off, which should bring the striker and spring out with the shroud.
 
OCowboy, there are at least two very different models of Voere centerfire rifles. One is a basic 98, the other not even close to a Mauser, but a bit like a Weatherby Mark V in appearance.

A picture would sure help.

Ted
 
Voere

Voere, made a couple of lesser known guns called the Titan and the Shikar most probably imported in the 70's and 80's. Complete dissasembly of the Titan bolt is not recommended unless you are a qualified gunsmith and even at that dont forget to draw a road map. Diagrams of at least one of these actions are found in Ottesons "The Bolt Action" books. Regards David.
 
You must log in or register to reply here.
Back
Top Bottom