Looking for help on these 9mm Luger primer oddities

[gurpgork]

I hope you guys can help me out. I recently got a new 9mm Luger pistol calibre carbine (JR Carbine 18.6" barrel). Loaded up the first 10 rounds in the rifle using factory Remington UMC 9mm Luger 115gr FMJ ammo. All fired and ejected well. I went to check the spent ejected cases for any odd signs. Note: I hand load 308 and 6.5CR and have had my fair share of light loads and over pressured loads; But I have never encountered this. Anyone know what this might be? I'm thinking bolt/firing pin issue ... (The dealer hasnt been too quick in responding) your thoughts?

 

[yomomma]

Soft primers

 

[sammer]

Mine look similar with blazer 124's, a bit more normal with blazer 115's
I thought it might be an issue when i first saw it but still going strong, no FTF's or popped primers, so just running with it.
Going to load up some with SRP and will see if it's light strike or soft primer cup issue.

Sam

 

[OldDude]

Maybe a combination of soft primers and an oversized firing pin hole?

 

[Eagleye]

Maybe a combination of soft primers and an oversized firing pin hole?

This would be my guess. Oversize firing pin hole in the boltface will cause this. Dave.

 

[Ruger007]

Even a weak spring can do that.

 

[Janeau]

It work fine ? Don’t worry about the primer.
They make gun to fire bullet..not to save case and primer.
Nothing to worry here…stop worrying..have fun.

 

[Wolf@TS]

My JR does the same.. nothing to worry about

 

[gurpgork]

Thanks y'all. I'll go out and have some fun.