Looking for rear ghost ring sight after shell holder install removed factory one

C

cdndfs

CGN frequent flyer
Rating - 100%
2   0   0
Installation of the Mesa tactical shell holder with rail required removal of the factory rail with the built-in XS rear ghost ring sight. I can’t just move it to the new rail because it doesn’t fit in the rail system since it has custom mount.

is there a replacement rear sight that would work well and be the right height or have elevation adjustments? Or should I just go with a red dot and screw the irons?

looking for some product recommendations.

thx
 
What Butcherbill said! Keep your existing sight and rail ....

Finding a ghost ring that has the correct height to work with your front sight might be tricky. You likely need a new front sight as well ...

I ordered a ghost ring and front sight for one of my 870 ... exact same part numbers as installed on a factory gun from Remington .... and that did not work. I had to order another higher front sight and in order to be able to shoot to point of aim at 50m ...
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom