Looking for reloading Brass

[MuskokaT]

Good Afternoon:

I have acquired a winchester 351 wsl and am looking for 351 brass to reload. I am also looking for some advice on swagging (resizing) 357 bullets down to the 351 size (352) or how to make a mould for making my own bullets? Any information that you can provide would be greatly appreciated. I am brand new to reloading (green horn, very green). I want to get off the right foot by getting as much information as I can before I start, and not break the bank. I would like to fire this gun in a sporting mode so I need an way to economically find or make ammunition for it.

Thanks for any help or information you can give me.

T

 

[graydog]

I did this years ago when I had one of these guns. Of course you first have to find the brass or loaded shells which isn't to hard for this cartridge. I cast some 38 caliber 160 grain round nose bullets and sized them down to the right dia. (the bullet was alittle deformed but worked just fine) and if I remember right I used my 357 mag dies to resize the cases and well Bob's your uncle.

Graydog

 

[MuskokaT]

Thanks:

Where did you get the dies to resize the 38 cal.? Did you have to make them or could you order them from a reloading manufac?

T