M14 safety switch issue and few other newbee question...

S

spirit

Regular
Rating - 100%
14   0   0
Hi!

I recently bought a norinco M14. The trigger seem working well but the safety switch is "painful". Somethimes I can't push it at without getting hurt. lololol No Joke.

I don't think it's a normal behaviour... I have try other M14 safety switch and it wasn't like that. How can I fix It?

My other question is about NEA vs Sadlak mag release and Smith Enterprise vs NEA Bolt Release. The NEA parts seem pretty large. Is it better?

Thank You!!!
 
you did #### it first?-as far as the other bits go, i've had one an awfully long time and found the issued mag release adequate
if it is that stiff, try pulling it out of the action, and work the safety out of the rifle- ie take the trigger group out of the rifle and work it back and forth out out of the rifle- just cushion the hammer so you don't break that off- a little grease might also be in order
 
I have polish the trigger group and everything in the gun is very well lubrificated. I will try to play with the sefety swich few undred times. We will see if it work's. thank you.
 
I had to do that with mine too. It was really stiff at first and it is silky smooth now. But I have fired about a crate through it. It will loosen up with time and use.

Shawn
 
What Tstar said , just dont try to put it on if the rifle is not cocked , its not meant to do that .

My safety was perfectly fine when i picked mine up , needed no attention .
 
You must log in or register to reply here.
Back
Top Bottom