I have a SA m1a loaded in a troy MCS stock. When the trigger assembly not installed the bolt does not rub the reciever at all but when the trigger assembly is installed as per the instructions (1/8" gap between trigger guard and trigger before it is pressed in place) the top of the bolt rubs the top of the reciever (and is gouging it) due to the hammer pushing up on the bolt. There are set screws to set the distance of the trigger assembly to the stock/reciever but if I move the set screws out any more to suck the hammer further away from the bolt the trigger assembly requires way too much force to get it to seat, its obviously not right. Any thoughts on how to correct this issue?
M1A bolt/receiver rub issue- Need ideas!
- Thread starter gutinater
- Start date
