mag loading tool

1st world problems. Lol.

article-2381876-1B0BEDC3000005DC-46_634x338.jpg
 
Lol. Super funny dudes. I actually cant use my thumbs yet..havent broken in enough yet...very tight . ..i press casing half in then slide back with my pointer on the nose . Balance next shell tail just behind nose and repeat..x20....cut my finger up a bit. No tab to relieve spring tension. Im a steelstud electrician and have rough hands. If there is a loader im getting it.
 
Alright...had sitting around time tonight , so decided to mess around loading and seeing what i could figure out...one thing i do know is reloading at the range in winter would be a PITA...

Ok check this out...feel the bolt open stop on the rear left of the empty mag? Its a black tab that compresses with the follower...
It slides down a channel. If you cut a piece of thin steel rod, like strong thin coat hanger or in my case steel stud seismic hanger wire, you can slide down the channel and compress the follower as you load . Not the greatest but tolerable for now...

Im not very well versed in mag loaders or 22s...so this is best i know so far...
Thoughts?
 
I am in contact with a manufacturer. They hope to have a price soon , but how many people would be interested? Also Wolverine has spare mags!!
 
On a side note a 1/8 steel welding rod cut to approximately 10 inches leaves room to bend a 1 inch ish loop in the end and then make a gentle curve to push the follower down threw the hole at the back of the mag :)
 
Also on a side note, the past few days i have seen several large online dealers pick up on selling this calibre skorpion , hope this means they catch on for minor mods and accessories like loaders
 
So a much overdue update. Received a parcel in the mail today and it was a sample loader. I had one mag that was short a round and it easily loaded it. I will try to get to the range this weekend and do further testing lol.
 
You must log in or register to reply here.
Back
Top Bottom