I have order a JP Enterprises, GEN2 AR-10 Silent Captured Spring Builder Kit w/ Alternative Spring Pack, Standard and I want to run a magpul prs gen 3 stock on the stag 10 I have coming. I have researched everything else to do with this rifle but I can't for the life of me figure out what buffer tube I need to run the Jp scs and a prs stock. Can some one please clarify what buffer tube I need. It's all I have left to order
Magpul prs gen 3 and buffer question
- Thread starter greg olmstead
- Start date
Mounts to rifle-length receiver extension tube without A2 spacer but will also accommodate mil-spec sized M4 Carbine and many A5-length tubes with standard Castle Nuts and End Plates (not included)*
*NOTE: Due to the wide variety of designs and dimensions of carbine receiver extensions as well as the associated mounting hardware, proper fit cannot be guaranteed. Mounting to a rifle-length receiver extension is recommended to ensure optimal fit and function.
That's directly from magpuls website so you can't go wrong with either. If you have a carbine buffer tube already try it out if you have nothing get a rifle length to be safe.
*NOTE: Due to the wide variety of designs and dimensions of carbine receiver extensions as well as the associated mounting hardware, proper fit cannot be guaranteed. Mounting to a rifle-length receiver extension is recommended to ensure optimal fit and function.
That's directly from magpuls website so you can't go wrong with either. If you have a carbine buffer tube already try it out if you have nothing get a rifle length to be safe.
