Magpul PRS stock

[mildot]

Well this is one of those questions that you need to ask a owner/operator?
I'm looking at a couple of used ones online, so I'm looking for one for a AR15 SPR build. The AR10 is said to have about 1/2" less cheek weld? Is this in the cheek piece height adjustment? The Gen-2 has the rubber butt plate, will the CTR butt plate fit on the PRS?
Does the butt plate affect the length of pull?

So will there be any noticeable difference? I want to make sure that I have enough adjustment. Prices are pretty close from both sellers.Both are advertised as new or near new.

Let me know what ya think troops?

 

[RobAK]

I've got a CTR and a PRS (I wasn't aware of the different generations though so I must have the Gen 1 by your description). On my PRS the CTR buttpad would not be able to go on without some drilling due to the screw holes for the pad.

Comparison:

 

[mildot]

Nice , you can always count on a CGN'er to go that extra mile!!
That said IYO would the rubber butt plate on the Gen-2 make any difference in you shooting position or LOP?
Looks like the butt plate doesn't make much of a difference?

 

[RobAK]

That said IYO would the rubber butt plate on the Gen-2 make any difference in you shooting position or LOP?

I've never seen one, but my ideal LOP right now has the PRS butt dialed out 5mm. So if it was for me on my gun, so long as the pad was 5mm or less I'd be fine.