Mannlicher parts?

[MD]

I have a buddy seeking original Mannlicher parts.

Specifically peep sights.

 

[tiriaq]

Lyman 34? Good luck...
A recent Mannlicher Collectors' newsletter showed a Williams Guide peep sight fixed to the top of a surplus Greek bolt sleeve. A higher front sight is needed.

 

[MD]

Lyman 34? Good luck...
A recent Mannlicher Collectors' newsletter showed a Williams Guide peep sight fixed to the top of a surplus Greek bolt sleeve. A higher front sight is needed.

He says there is one that mounts on the cocking piece and another that attaches elsewhere.

 

[tiriaq]

The Lyman 34 replaces the bolt stop, and has a windage arm that wigwags as the root of the bolt handle passes it. I have one on my 6.5.
A cocking piece sight is another option.
These vintage sights are uncommon, and are pricey when the surface.
The addition of the Williams sight to the bolt sleeve is an inexpensive option, if a surplus bolt sleeve can be obtained.

 

[gunrunner100]

The Lyman 34 replaces the bolt stop, and has a windage arm that wigwags as the root of the bolt handle passes it. I have one on my 6.5.
A cocking piece sight is another option.
These vintage sights are uncommon, and are pricey when the surface.

 

[AP]

Lyman #36 ... is one option... check the link before it goes..
http://forums.gunboards.com/showthr...yman-36-Rear-Sights-for-Mannlicher-Schoenauer

 

[AP]

The Lyman 34 replaces the bolt stop, and has a windage arm that wigwags as the root of the bolt handle passes it. I have one on my 6.5.
A cocking piece sight is another option.
These vintage sights are uncommon, and are pricey when the surface.
The addition of the Williams sight to the bolt sleeve is an inexpensive option, if a surplus bolt sleeve can be obtained.

I believe it is the Lyman #36 .. have a look at the link in my previous post...

 

[tiriaq]

I was wrong on the "34". Gunrunner's photo, and the link you posted show the Model 36 bolt release sight.

I have a Lyman cocking piece sight and its mounting base, nib, for a 98 Mauser, but it is in the shop, so I do not have the model number at hand. I assume the sight could be fitted to a MS with the appropriate adapter base.