Mauser 98 trigger guard measurment

[Anfoman76]

Hi Guys, I was wondering if someone could do me a favour? Could you measure your 98 Mauser trigger guard for me? I just need to know the width of the front and rear where the mounting screws go through. The outside width from edge to edge. Any help would be much appreciated.

 

[Nabs]

Are you looking for the guard screw well width or the width of the section including the surrounding metal ?

 

[Anfoman76]

The surrounding metal area. The trigger guard itself.

 

[Nabs]

I got these measurements from one of my Gewehr 98s, measured at the widest visual point:

Front trigger guard screw area: 1.75 cm
Rear trigger guard screw area: 1.6cm

Hope this helps you out.

 

[Anfoman76]

It did thank you very much.

 

[Pblatzz]

 

[Anfoman76]

Thanks PB but I was looking for the width of the trigger guard

 

[Pblatzz]

Thanks PB but I was looking for the width of the trigger guard

At what point? Front back, Middle, Front of mag well? the whole thing I'm guessing? I will see if it can be done.