Quick question for anyone running a Dlask action in an MDT x dlask chassis — what torque values are you guys using on the action screws? Specifically the main T25 action screw and the top rear tang screw. Want to make sure I’m not under or over-torquing before I take it out. Any numbers or a link to MDT’s spec sheet would be appreciated. Thanks!
MDT x Dlask Chassis Torque Specs
- Thread starter economics
- Start date
MDT is between 20-45 in-lbs in their chassis but they always defer to the manufacturers specs.
For Dlask 10/22 or DAR-22 action screws (takedown screws), the recommended torque specification is 20 to 25 inch-pounds, with 24 inch-pounds being widely considered the optimal "sweet spot". Do not exceed 30 inch-pounds.
For Dlask 10/22 or DAR-22 action screws (takedown screws), the recommended torque specification is 20 to 25 inch-pounds, with 24 inch-pounds being widely considered the optimal "sweet spot". Do not exceed 30 inch-pounds.
Thank you!
So would 24 be for the bottom action screw and the rear tang? Would the rear tang be different?
I bought the firearm used and since dlask shutdown I wasn’t able to check with them re: any manuals/documentation.
I also emailed MDT but they deferred to Dlask while also mentioning usually 30 should suffice.
So would 24 be for the bottom action screw and the rear tang? Would the rear tang be different?
