Midwest Industries PC9 M-LOK Handguard $249.99 and Charging Handle In Stock

[ctcs]

• Lightweight design with a slim profile
• True Free Float Design
• Mounting bolt and wrench included
• 12.0" overall length
• Three built in anti-rotation QD sockets
• Features 8 sides of M-Lok slots
• 5-slot polymer M-Lok rail included
• Weight 10.9 oz installed
• Construction from 6061 aluminum, Type 3 hard coat anodized for a lifetime of service
• Fully dehorned for a non-abrasive, comfortable feel

$249.99



Midwest Industries Ruger PC9 Bolt Handle

• Slightly longer than factory handle with knurled exterior for better grip
• Constructed of 4140 steel with Mag Phosphate finish
• Uses factory bolt for install *Does not include new screw*

$29.99

 

[Patriot762x51]

Can you get there
Combat Rifle Offset Sight Front #MI-CRS-OSF
Combat Rifle Offset Sight Rear #MI-CRS-OSR

 

[Sakonut]

Did some googling without success... Any word on whether or not the receiver Picatinny would line up height-wise with a picatinny section attached at the 12 o'clock on that handguard? I'd be interested in running a set of flip up BUIS and removing the factory ones to get a longer sight radius...

 

[Dr.Islay]

Would be interested in the aluminum spacer plate with the QD sockets (MI-PC9QDSP) if you can grab these.

 

[Standingtall]

Any chance you are going to try and get the Copper Custom Armaments chassis?

[

 

[JeffMan]

Damn. I was too slow!

 

[one_lion]

Any chance the 14in extended version (MI-CRPC9X) will be available sometime?

 

[rifleman338]

Any chance you are going to try and get the Copper Custom Armaments chassis?

[

I'd be all over that