Model 7.......?

[kamlooky]

Remington Model 7 in 308win.
Synthetic stock.
New.

What do these things fetch furr $$ now a days?
Sitting on the fence on uno.....................................................

 

[jiffx2781]

Epps has a Model Seven Synthetic in 7mm-08 for $802.10 so that might give you a bit of an idear.

https://ellwoodepps.com/remington-seven-synthetic-210752.html

 

[NL-Hunter]

Let me know where you can find mounts for a 7 if you get it.

 

[double gun]

2-piece talley ultralights- prophet river
1 or 2 piece leupolds from pretty much any leupold dealer.

 

[flipincanadian]

I’ve got mine listed for 1200 with a leupold 2.5-8.

 

[Fisherguy55]

Let me know where you can find mounts for a 7 if you get it.

Call Prophet river, had stock when I bought one set of Talleys. The low mount fit a 3-15x42mm Zeiss

 

[3screwsloose]

I have two sets of mounts rings available for the model 7 if anyone has issues with availability

One piece steel base with dual dovetail blued with low rings Leupold new/new

And two piece turn in style stainless with medium rings Leupold new bases lightly used rings

Cheers

 

[kamlooky]

And now you show up.............................

 

[Neilm]

I believe the early model 7's had only one hole drilled at the rear and you have to use the one piece base

 

[double gun]

Yes, the early ones only had a single rear screw. Many 1-piece mounts for the 700 short fit the m7 aswell. Since the rear hole on a m7 is in the same place as the 700 sa front rear screw. About the same time Gentry offered his ultralight mounts that were two piece and only used the single rear screw and it seemed to work fine. So you could probably run most 2-piece mounts with only one screw in the rear bridge. But the best idea is to just have the second hole drilled and tapped for the added security.

 

[220]

EGW for rails if want one

 

[remington jim]

DNZ Game reaper - All 1 Piece ! RJ

https://www.dnzproducts.com/product/game-reaper-remington-3/

 

[DANS40X]

Rem Model Seven w/ 2 drilled & tapped #6-48tpi holes in rear bridge/receiver ring.

Blued receivers w/ serial number higher than 773800
Stainless receivers w/ serial numbers higher than 762800

Previous serial numbered receivers have one drilled & tapped hole of which a 700 S/A 1 piece base will fit.

Either may require a shim under rear base to level w/ front base aka 722/721's.

 

[kamlooky]

Ohhh, it's gitt'in closer.................................

 

[dan belisle]

Ohhh, it's gitt'in closer.................................

I have a couple sets still I think, if you can't find any. is it a 3 screw receiver or 4? - dan

 

[kamlooky]

I have a couple sets still I think, if you can't find any. is it a 3 screw receiver or 4? - dan

It's not here yet.
Carrot dangl'in in front of me snowt.

It's new so whatever Remington has done currently.

Thanks for the offer db.