Modern Sporter - Build Discussions

ATRS If it's a known issue perhaps you guys could include pivot pins with purchase? I can't imagine it would add much to the cost and it would eliminate a lot of headaches for customers buying LPKs that have an out of spec front pivot pin.
 
I've got mine mostly setup. However I had to go through 2 bolt catch pins. The first one got stuck and the roll punch slipped.. Scratched the lower :(

Anyways 2nd one wouldn't go in all the way even using the Wheeler Delta tools specifically made for bolt catcher pin. So now I've got it slightly sticking out... I think I'll need to get another pin later to replace this one too..

But I guess I was bound to screw up something seeing as this is my first build ever...

Anyways... All in all.. I'm still happy. Once it's ready to shoot I'll post a pic

Will need to upgrade to a better (unmarred) buffer tube sometime too... But if they gonna get banned anyways.. Might as well be happy with this lol
 
Anyone have issues with DPMS forward assist kits? The assist itself is slightly too large for the roll pin and causes it to jam up during the installation unless the MS upper has the roll pin cut too close to the assist's pocket, which I doubt (but it is ~2 thou of an inch). The roll pin fits fine; during some dry fits it seated well but the assist looks like it is just slightly too large.
 
Yes I have the rattle as well. Could see light between upper and lower. Put some tape on the rear pin and it reduced the play. Front pin is still loose. It's a BCM kit pin. I'm not sure what I could do to tighten that. I'll measure the pin as advised.

Thanks
 
I've got a Daniel defense lpk in my 2nd run sporter and I've had the bolt hold open plunger come out around the bolt catch lever without me realizing it. Has anyone else had this happen? Or does anyone have a recommendation on a bolt catch that sticks down a little further to hold the plunger in? My spring is still in there luckily!
 
Garrettgrant said:
I've got a Daniel defense lpk in my 2nd run sporter and I've had the bolt hold open plunger come out around the bolt catch lever without me realizing it. Has anyone else had this happen? Or does anyone have a recommendation on a bolt catch that sticks down a little further to hold the plunger in? My spring is still in there luckily!
Click to expand...

Hey would you happen to have pics?
 
dawildqc said:
pretty quiet arround here now :(
Click to expand...

Typically same day or next day. depends on how slammed we are from day to day as well as how much staff is at work on a given day. This last week has been brutal with sick, doctor and assorted other things that have left us short staffed out front.
If you have paid in full and we have not sent you an emailed copy of your invoice within a few days please email us at the shop so we can get it dealt with.
 
alberta tactical rifle said:
Typically same day or next day. depends on how slammed we are from day to day as well as how much staff is at work on a given day. This last week has been brutal with sick, doctor and assorted other things that have left us short staffed out front.
If you have paid in full and we have not sent you an emailed copy of your invoice within a few days please email us at the shop so we can get it dealt with.
Click to expand...

Email sent, thanks you!
 
You must log in or register to reply here.
Back
Top Bottom