Modern Sporter - Build Discussions

soforcy said:
%E7%85%A7%E7%89%87%202018-10-31%2011%2001%2012.jpg


Got every parts for MS build today!
Can’t wait for the receiver lol.

(Don’t know how to show pics here... so here is the link)
https://www.dropbox.com/s/3f3pn330e275xpb/%E7%85%A7%E7%89%87%202018-10-31%2011%2001%2012.jpg?dl=0
Click to expand...

p.jpeg
 
No, generally it will just require a little more care to detail when installing it to ensure proper alignment. After it's aligned, and you confirm it via firing it, then put a little blue loctite on the threads of the set screws one at a time and you're set.
 
ATRS Shaun said:
I doubt that. Fastenal carries a variety of them, a lot of lower parts kits come with them. The ones that are in LPKs and come long, I think it's like ordering action screws for a Remington 700. They usually come long, because it's easy to cut them down.. but if you've ever tired to stretch a bolt that's too short... whole other story.

And that being said, absolutley nothing wrong with the washer or spacer system either. Long as your grip is holding firm with no wiggle, life is good.
Click to expand...

Magpul offers their grip screw by itself, using one of those with a lock washer from a regular LPK and seems to work fine. Its quite a bit shorter than the one that came in the LPK.
 
since You asked I’ll tell you my thoughts, it’s ugly as duce and I would never buy it and I would slap myself for thinking of buying it;)
Problem is nobody cares what I think is ugly, so do what you like and enjoy the hell out of it.

As long as it’s not from turkey it’s A OK
 
jiffx2781 said:
Hahaha, yup thanks for the honesty.

A somewhat local shop has one in stock so I'm going to go take a really good look at it before I decide to put money out or not. It is different but I sometimes don't mind different.

Main thing that concerns me without physically handling it before buying is build quality. But it is made in the USA. Still doesn't mean it's any good though.

Or perhaps I'm just having a temporary relapse from an old head injury and it's impairing my judgment... ???? Happens from time to time lol..

Ya I'll probably do the right thing and buy a JP handguard.
Click to expand...

Have you looked at the BCM MCMR? I have the 15" model, very impressed with it so far (granted it's not installed and tested yet) and it is super slim + light. Not sure what your budget is though, as it will tip the scales around $300.
 
xeelee said:
What type of handguard is that? Nice clean lines...I like it
Click to expand...
Maple Ridge Armoury SLW. I think it has been replaced by their V1. I have the same hand guard on an upper and I am quite happy with the fit, finish and feel of their products.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom