moonclips for 686

Why not just use speed loaders? IIRC, the cylinder will need machinging to accept moonclips.

That being said... http://www.tkcustom.com/ makes and sells them. Should be a non-issue getting them shipped.
 
I have talked with tkcustom they can do the job but its a nightmare to have it shipped back to me they told me they dont have the permits i use speedloaders now and they are slower compared to moonclips
 
If you were to get the moonclips, it would probably be a LOT easier to find a machinist on this side of the border that could machine the cylinder out for ya.

p.s. I shoot PPC with a 686 w/speedloaders..for the fraction of a decrease in load times I may or may not see...I'd rather keep my cylinder to spec...but that's me :) To each his own!
 
Do you already have a source for .38case sized moonclips? I'd think those would not be that common.

You may want to consider getting a new gun to use with moonies. A 610 so you can shoot .40 S&W or 10MM or a 625 and use .45ACP. That way you can keep your 686 stock or just sell it to finance the new moonie gun purchase.
 
You must log in or register to reply here.
Back
Top Bottom