Moonclips ?

[shortround]

I am looking for full moon clips and a loader /unloader . Can someone recommend where would be the best place here in Canada to get these for my .45acp S&W would be ?
I ordered some moonclips on-lineand when they arrived they were only half moon clips . I am a babe in the woods when it comes to this as of yet . I tried to return then and was basically told to get stuffed and that I should get some glue and glue then together. I didn't even know that there was a differrent type other that a different one for the seperate model of firearm.

Thanks for your help !!

 

[RePete]

Brownells have them.

RePete.

 

[pfbmgd]

Try these guys .I have their rubber moon clips and they work great .


http://www.ezmoonclip.com/page_2.htm

 

[SDC]

Armco's got a special on moonclips right now ( http://www.armco-guns.com/bulletin_board.htm ), but I've also ordered them from Cactus Tactical in the US ( http://www.cactustactical.com/bladetech/moonclips.html ), and I've got some of the RIMZ from Beckham Design, the manufacturer ( www.beckhamdesign.com ).
I've also got one each of the demooner/remooner tools from California Competition Works ( http://www.demooner.com/pistols.php ), available through Dillon; very handy.

 

[Zortag]

not to hijack, but can one get a revolver milled for moonclips? I've been toying with the idea for a while....

 

[Dragoon]

not to hijack, but can one get a revolver milled for moonclips? I've been toying with the idea for a while....

Yes.

 

[SDC]

Here's a picture of a S&W 66 (357 Mag) that has been machined so it'll work with either loose rounds or moonclips; loose rounds are still supported by the raised rim around the edge of the cylinder, but the center is recessed to take moonclips.

 

[Zortag]

right, I`m an idiot. I meant to ask where can one get a revolver milled to accept moonclips.....

 

[Ike]

right, I`m an idiot. I meant to ask where can one get a revolver milled to accept moonclips.....

Armco can do the work... I am going to send one to Gunnar for that same thing.

 

[Zortag]

Does Armco do the partial milling like in the pic SDC posted?

 

[7x61]

Yup, that's how we do it

That way you can use loose rounds, speedloaders, and full (or half) moon clips.

Gunnar
www.armco-guns.com

 

[Zortag]

thanks gunnar....looks like I`ll have more work for you now