MR1 question

1899

1899

CGN Ultra frequent flyer
Rating - 100%
38   0   0
Location
West
I see some MR1 Ghost models advertised - they have a collapsible stock. I cannot find any specs on Benelli's web site. Does anyone know the LOP when the stock is fully collapsed?

Thanks.
 
1899 said:
I see some MR1 Ghost models advertised - they have a collapsible stock. I cannot find any specs on Benelli's web site. Does anyone know the LOP when the stock is fully collapsed? Thanks.
Click to expand...

I just handled one the other day, and it's comparable to the one on a Benelli M4. I didn't find you could get a good cheek weld with the stock fully collapsed, though. Unfortunately, my brief experience with the MR1 didn't leave me with anything more than a "meh" impression, but mileage varies...
 
1899 said:
I see some MR1 Ghost models advertised - they have a collapsible stock. I cannot find any specs on Benelli's web site. Does anyone know the LOP when the stock is fully collapsed?

Thanks.
Click to expand...

13 and 3/4 LOP 2 positions open and close, for the cheek weld i prefer the strait stock both on my MR-1 and my M4... JP.:shotgun:
 
Using a tape measure from stock to trigger I get:

Fully extended the LOP is 13 3/4 inches.
At mid-extension the LOP is 11 inches.
When closed the LOP is 9 inches.
 
Last edited:
Mine has 5 stops: 9,11, 12, 13, and 13 3/4. I am 6' 2" and use it full out while my 5' 4" wife prefers the 12 setting.

Something else to consider for folks with small or junior shooters around.
 
bc308 said:
Mine has 5 stops: 9,11, 12, 13, and 13 3/4. I am 6' 2" and use it full out while my 5' 4" wife prefers the 12 setting.

Something else to consider for folks with small or junior shooters around.
Click to expand...

My mistake this is right the MR-1 is multi position and the M4 is open, middle and close,if i recall correctly, dont have them on hand here, though you want open LOP... JP.
 
You must log in or register to reply here.
Back
Top Bottom