My 50 cal spire point mold had a baby :)

[Spawn-Inc]

Picked up a new 38/357 mold from NOE, 154gr spire point (came out to 160gr with lube and gas check)

And a couple loaded up, i need to modify my seating die because it turns them into flat points.

 

[zuke]

Those look like fun!

 

[Seagull]

Your fingers are going to bleed one of these times. Those look sharp (pun intended).

Any Powder coated yet?

 

[Spawn-Inc]

I find the 50's tend to be sharper but that's all I've cast so far, no blood shed yet . I definitely will be powder coating them but none so far. I'm hoping I could try them in 9mm but I don't think they will work unless I load them in my ruger convertible. NOE also has a 96gr and 138gr that would likely work in the 9mm but I wanted a heavier bullet.