My first Norinco M14 rifle

R

roberti11

CGN frequent flyer
EE Expired
Rating - 100%
76   0   0
Location
Toronto
Here is my first Norinco M14 rifle:

Norinco M305 Bbl cut to 18.5 inches, Twist 1:12
M-14 SOCOM Aluminum stock set (AKM)
Vortex Flash Hider
Navy Front Sight
R-33 Stainless Guide Rod
Smith Tac Latch
RAA-Car 15 Butt Stock
ERGO Pistol Grip
SuperSniper 20X fixed power Scope, TPS rings, Zeroed to 100 yards
1x33mm Reflex Red Sight, mounted on CORA (TPS) Zeroed to 30yards
Specter M-249(SAW)/(SOP) Sling

M14Norinco01.jpg



M14Norinco02.jpg


M14Norinco03.jpg


M14Norinco07.jpg


M14Norinco08.jpg



I am still working up a load, I will post a full range report soon.

http://www.shootershaven.net/M14Norinco.html
 
Last edited:
Awesome setup....
Am I mislead by the picture positioning, or is the front sight canted to the left (operator's view)?

I like the holosight on the side. Can you engage targets 100yds away with that?
 
eltorro said:
Awesome setup....
Am I mislead by the picture positioning, or is the front sight canted to the left (operator's view)?

I like the holosight on the side. Can you engage targets 100yds away with that?
Click to expand...

No the front sight is straight, the angle of the picture is misleading.
The Holosight is zero'd for 30, because of the angle it is set at you have to aim at the targets right shoulder to hit centre mass of a stanadard IPSC target at 50 yards. For 100 I just use the scope. I set the holosight so that with both eyes open I can actually see both (holosight, and scope reticle) at the same time, if the target is far I use the scope, close the holosight. I have used it once at an IDPA match, it was not bad considering I used a load out of the book and have not yet set about tweaking it.
 
You must log in or register to reply here.
Back
Top Bottom