NEA 14" 870 barrel?

cdncowboy

cdncowboy

CGN Regular
Rating - 100%
80   0   0
I would like to get a 14" barrel for my 870 ... does anyone have experience with the NEA barrel?

IMG_0946.JPG
 
dont waste your money. there is another thread further down with people having nothing but problems. i bought mine without seeing that thread and have had nothing but problems.

it's a sad day when it might be a safer bet buying chinese than canadian.
 
cdnSTIG said:
dont waste your money. there is another thread further down with people having nothing but problems. i bought mine without seeing that thread and have had nothing but problems.

it's a sad day when it might be a safer bet buying chinese than canadian.
Click to expand...

What problems have you had?
 
Chemist said:
That's not even the same barrel. These 195 were made for me at a later date, non parked chamber and bore and a different profile. Good try.
Click to expand...

testy, testy. He was getting at the quality fail of the BBL's, as per the attached thread. Parked bores, chambers. Just chalk it up to another failure by NEA. That is all he was gettin at. there are better , more reputable BBL's out there, which dont have these issues, and likely never will.

Oh but these ones are good to go. :rolleyes:
 
Opps, good try was supposed to be removed :)

But on your note, these are different barrels, non parked bore and chamber, slightly different profile so they don't hit the forend etc. I took your guys suggestions and had them changed.

jdman said:
testy, testy. He was getting at the quality fail of the BBL's, as per the attached thread. Parked bores, chambers. Just chalk it up to another failure by NEA. That is all he was gettin at. there are better , more reputable BBL's out there, which dont have these issues, and likely never will.

Oh but these ones are good to go. :rolleyes:
Click to expand...
 
Chemist said:
Opps, good try was supposed to be removed :)

But on your note, these are different barrels, non parked bore and chamber, slightly different profile so they don't hit the forend etc. I took your guys suggestions and had them changed.
Click to expand...

Guess it is to bad for the guys who tested them out first batch. I would like to see how the new ones compare to the one I have!
 
Last edited:
I'm still tempted to try one of these. I've spent a way too much of firearms stuff in the last little bit (wifes opinion) and if i can save 150 bucks...I may take a drive down and see them if person, maybe bring my old wingmaster receiver down to make sure they fit. If I do, I'll post the results.
 
freddyfour said:
Gotta remember to with these barrels, there is no sight so your probably looking at another $100 to $200 for a decent sight on top of the $150.
Click to expand...

My receiver is already tapped and has a rail, but is that really the going rate for a post sight attachment??
 
I'd never trust NEA for anything ever again.
Fit and finish was the worst I've ever seen, the brazing of the barrel ring looked like if it had been done by a 2yo... Amongst other thing, but I'm not going back there... Night and day on EVERY level next to Dlask.
Oh but this is the new new, not the new... WTV
 
You must log in or register to reply here.
Back
Top Bottom