Ordered a Wilson case trimmer from Sinclair, how do I go about getting a custom shell holder.
I'm looking for a Sako 7x33 shell holder, wilson will fabricate but they require 3 empty shell.
Of course there is the export issue, what would be the best way to deal with this?
On another matter is a case neck turner, I will be reloading; Sako 7x33, 222 Rem Mag, 243 Win, 308 Win and 375 H&H.
I heard that brass will flow and thicken at the neck and may cause an over pressure issue.
In case you did not guess it I'm new to reloading a would appreciate any advice.
Bob
I'm looking for a Sako 7x33 shell holder, wilson will fabricate but they require 3 empty shell.
Of course there is the export issue, what would be the best way to deal with this?
On another matter is a case neck turner, I will be reloading; Sako 7x33, 222 Rem Mag, 243 Win, 308 Win and 375 H&H.
I heard that brass will flow and thicken at the neck and may cause an over pressure issue.
In case you did not guess it I'm new to reloading a would appreciate any advice.
Bob
