Need a new tc .54 ramrod...any help please

[lobsterman89]

Already checked cabelas and they dont have a replacement rod for a renegade.

you could just take a 3/8" dowel from a hardware store, cut to 26 5/8" and put a brass ramrod cap found at many websites on the end. you could stain it to make it fit the rifle better too. this should fit in the ramrod groove and everything. but if you're determined to get a T/C renegade ramrod, here's one from track of the wolf:
http://www.trackofthewolf.com/Categories/PartDetail.aspx/567/1/RAMROD-265-TC it's the actual one that comes with the gun from T/C, synthetic...likely fiberglass.

 

[tiriaq]

Ramrods can be easily made. Be careful with hardware store dowels - if there is crossgrain in is possible for the ramrod to break, resulting in a sharp edge being driven into/through the hand.
It can be better to use hickory dowelling actually intended for use as ramrods.