Need grizzly parts
- Thread starter rally guy
- Start date
Yes they will, but the rivot might be a problem.
Your best bet is to contact Arwen Ace from TacOrd, and have him look at it.
The issue with the chinese rivit is it's not the same dimentions as the Remington. If it needs to be replaced, the reciever needs to be milled for the Remington part.
Mine went south and Casey had it up and running the next day.
Your best bet is to contact Arwen Ace from TacOrd, and have him look at it.
The issue with the chinese rivit is it's not the same dimentions as the Remington. If it needs to be replaced, the reciever needs to be milled for the Remington part.
Mine went south and Casey had it up and running the next day.
Now the bad news/ good news about this is;
1) You might as well replace the ejector while you are at it for the more robust Remington part.
2) You may want to consider having the gun refinished, because if the rivot needs to be replaced, it's peened in place.
1) You might as well replace the ejector while you are at it for the more robust Remington part.
2) You may want to consider having the gun refinished, because if the rivot needs to be replaced, it's peened in place.
mudgunner49
CGN Ultra frequent flyer
And at some undetermined point in the future the Chinois rivet will fail. Save yourself the hassle - send it to Casey...
