Need some help here

[cdnloki]

I have a Pre 64 Winchester model 100 carbine in .308 , in which the stock has split on. So I'm wondering if any of you have come across a replacement carbine stock anywhere in your travels. I would prefer to keep it original..which i know will be tough. Or if not do you have any suggestions on what I should get to replace it. Sorry if this is in the wrong place.

thanks in advance

 

[jag]

How bad is the split? If the stock is still straight or can be straightened you can send it to someone with a stock duplicator.
I'm just about to send a Mod.100 stock in to be duplicated in black/grey laminate.
If you think this will work for you PM me and I will give you contact info.

 

[RememberTheSomme]

Jag is that on rifle or a carbine and what is the approximate cost if you don't mind my inquiry.

 

[reb]

Depending on the split Accra Glass work great for a repair.

 

[cdnloki]

the splits pretty bad. I'll see if i can get some pics...I don't think its repairable

 

[cdnloki]

Does anyone think that this is repairable ? Or should i just get a new stock ?

 

[guntech]

That split is repairable. If no one screws it first with a poor attempt.

 

[mstewart]

Shane at Reliable Gun repaired a model 88 with similar crack. He pinned it and glued it. Can barely see the crack. I think it was $75. I haven't shot it hard since but it's still holding up.

 

[mikeystew]

Yup, it can be repaired by knitting it together with pins and good adhesive. I fixed a cracked engine block on a 1953 ford/worthington tractor by knitting it with steel pins and jb weld, and it's held up for years.