New B&C stock for my Tikka T3

I just got my 2 last week.

1-4.jpg


My 6.5 on top in black and my 338 Fed in olive green on the bottom.
Sorry for the poor lighting in the picture, it doesn't show the colours very well.
 
Hey Clay.........I have the springs to get the Tikka trigger pull down to 11 ounces, adjusts back up to 2.5 pounds with the same spring........makes for a nice light crisp trigger
 
I got a green one from prophet river too! Clay is great and service was unreal - very quick. Does anyone know how to torque these to spec. I am assuming that you don't just hand tighten and a specific ft/pd of torque is required. Can a guy get a torque screwdriver for cheap? I am hoping this stock gets me closer to sub moa. My original action block had 3 - 4 mm of movement no wonder it was dancing.
 
they cant take much torque - its not the stock, but the cheesy plastic trigger guard - its tough, but it doesnt have support for the screws, so as you tighten them past 30-40 they eat right thru the plastic. I had to replace one trigger guard already, and they are crazy expensive!
I wish they would make them out of aluminum....
 
powerbaitron said:
I got a green one from prophet river too! Clay is great and service was unreal - very quick. Does anyone know how to torque these to spec. I am assuming that you don't just hand tighten and a specific ft/pd of torque is required. Can a guy get a torque screwdriver for cheap? I am hoping this stock gets me closer to sub moa. My original action block had 3 - 4 mm of movement no wonder it was dancing.
Click to expand...

A torque driver is good if your unsure, check specs. I just hand tight them snug, no need to power torque them.
 
You must log in or register to reply here.
Back
Top Bottom