New : Glock Slide Mods

[Danimal247]

those holes look a little off center...?

I just picked it up from Joe at Dlask. Great work!

Here are some more pics!

 

[mattcrossan]

those holes look a little off center...?

No the camera angle is off a little. They are perfectly lined up to the slide cuts.

 

[hamermill]

Prices for both mods are listed. Do you have a calculator?

Thanks SFB - when you grow up you will learn that asking to confirm something is better than assume.

 

[onetwentyish]

Thanks SFB - when you grow up you will learn that asking to confirm something is better than assume.

Good job at coming out of the gate swinging, and name calling. And I am the immature one?

I simply dont see what was needed to confirm there. Both mods are very clearly listed with prices for each. Might be time to look for a reading comprehension course to give you a boost so vendors dont have to copy and paste thier same post to get the point across.

 

[lucsergerie]

Hi guys

Can you do this on a TSD slide?

 

[skip1600]

Can my 40-9mm lonewolf barrel be ported with the 40 slide... Can I send 2 barrels with one gun to be ported and what would the cost be

 

[ridgearms]

what is the benefit of the porting?

 

[bruin048]

what is the benefit of the porting?

You have to keep your windows rolled up on your car to stop the ladies from jumping in.

 

[ridgearms]

You have to keep your windows rolled up on your car to stop the ladies from jumping in.

I meant besides what is obvious

 

[Brocolt]

What would be the total cost for the above mod?

Prices for both mods are listed. Do you have a calculator?

how does a calculator work? can you demonstrate?

 

[Brocolt]

Joe, any chance you guys have access to Glock 17 sides? just don't feel like hacking my factor slide yet as it's still on warranty. I'm glad your offering these new mods - you'll be busy.

 

[xandrewx]

so is that a no on just slide serrations ?

 

[jugi16]

Couple questions

How much velocity do you lose? Will it require a different slide spring?

 

[onetwentyish]

Leigh,

I am looking to send my M&P9 slide and barrel assembly to you in the near future for mainly barrel porting.

Some other things I am interested in knowing is if you can mill down the slide a little on both sides to get rid or the laser etched "CAUTION-CAPABLE OF FIRING WITH MAGAZINE REMOVED" and some small serrations towards the front of the slide.

Lastly, I just got a set of VTAC sights put on my M&P9 that I would like to keep, and just have a slot milled ahead of it for something like an RMR that could take on/off at will.

My M&P9

Penciled out spot I would like milled off and forward serrations.

And for the ports I would like keep all the cuts on the angled parts and not the side so as not to interfere with the "Smith and Wesson" or "M&P9" etchings.