Nightforce Question????

Remington country

Remington country

Regular
EE Expired
Rating - 100%
15   0   0
Location
Fort Mcmurray
Hey guys

I Recently bought a 5.5-22x56 NXS with Zero Stop. I have it mounted on my new rifle just in the middle of developing my load and was wondering on my side to side adjustment is that Zero Stop as well or do i just leave it where it is when I'm done sighting it in. THanks I know the Side turret doesnt look anything like the Top elevation turret.

Newrifle3.jpg
 
Underthegun said:
Your windage turret does not have the zero stop feature.
Click to expand...



this ^ is much easier and quicker to hold your wind adjustments then it is to dial it, so most people never touch it once the rifle is zeroed

Remington country said:
ill just have to note exactly where I leave my windage turret after I'm done load development.
Click to expand...

why? you can loose the set screws in the turret and reset the knob to read "0"
 
Remington country said:
Thanks I kinda Figured it did not So I'm guessing ill just have to note exactly where I leave my windage turret after I'm done load development.
Click to expand...

Not sure if you have done it before, if not like the previous poster said reset the turret to zero. To do so there is a real small Allen screw that holds the turret on Loosen it and the turret cap should spin freely without changing the settings. Night force scopes come with a small Allen wrench that is intended to use for this purpose. Line it up with the zero and tighten the allen screw. Works great. If you are well aware of this sorry to break it down. I post this for the benefit of others as well as not everyone is aware you can do this.
 
Nice rig ... Sounds like your first night force ? If you get that gun shooting,wait till you try it at a 1000 yards. Ive got the same scope " high speed zero stop " unreal long range scope ! Enjoy !
 
You must log in or register to reply here.
Back
Top Bottom