Norinco CQA Gas Tube

[terBC]

Has anyone had any experience in removing the gas tube from a CQA? From what I've read the pins for the gas block itself are a pain and most people have recommended cutting down the FSB instead of trying to replace the gas block. What about the roll pin for the gas tube is that also a pain and won't come out?

Thanks.

 

[wbaad]

Probably because you need a punch? Not sure what the big deal is either.

 

[Juster]

I had no trouble removing the gas tube.

 

[*MALICE*]

Both the taper pins (for holding the gas block onto the barrel) and the roll pin (keeps the gas tube in the gas block) are easy to remove so long as you use the correct tools.

 

[SteelCap]

Both the taper pins (for holding the gas block onto the barrel) and the roll pin (keeps the gas tube in the gas block) are easy to remove so long as you use the correct tools.

And punching in the right direction.

 

[terBC]

Thanks for the feedback everyone

And punching in the right direction.

If i'm facing the front of the barrel am I punching right to left or left to right?

 

[lerch641]

Pins should go left to right, so hammer on the non-ejection port side and remove them on the ejection port side.

 

[terBC]

Pins should go left to right, so hammer on the non-ejection port side and remove them on the ejection port side.

Perfect thanks!