Norinco CQA gasblock question.

[mrbishi]

Leave it soak in wd40 and use the right size drift pin punch, going the right direction. I ground it down anyways afterwards rather than spending another $50.

 

[shawnboy]

Touching back on reinstalling the oem parts for resale...

Seeing as how I am gathering parts that are slightly above Norinco payscale, would it not be more prudent and fun to build a separate barrel that could just be swapped to a new upper if I were to choose to upgrade?

What would be a decent barrel should I opt to go this route?

 

[Stevo]

Touching back on reinstalling the oem parts for resale...

Seeing as how I am gathering parts that are slightly above Norinco payscale, would it not be more prudent and fun to build a separate barrel that could just be swapped to a new upper if I were to choose to upgrade?

What would be a decent barrel should I opt to go this route?

Personally, I have a lot more fun with my angle grinder than I do with my barrel wrench.