Norinco M-93 .22

D

DaveF

CGN Regular
Rating - 100%
336   0   1
Location
Airdrie, AB.
Hi All.
I've just picked up a used M-93 as a get-started pistol for my grand-kids to learn with, but don't have any field strip/parts breakdown literature for it.
Could any one of you good guys tell me how to strip it, or if possible scan and send me the info to - dflather@telus.net ??
Regards, DaveF.
 
A word of caution as I have one.
There are some sharp edges inside them. Nice guns but a little rough around some edges.

I sliced a finger when I took mine apart. 10 minutes with my Dremel fixed the gun though.
 
I have one as well, haven't taked it apart yet...For cleaning I just lock the slide back and clean what I can with a Q-tip...

just wondering how much did you pay for it used?
 
Take special attention of the recoil spring.

Mine pistol was rough, so I decided to "clean it up". Well worth it, but the spring is next to impossible to get back in without the correct technique.
 
Norinco

Thanks Guys.
I decided to press on regardless, in the best tradition of "it can't be that hard". Well , IT IS!!!!
Raider 556 - thanks for the link.
colinjw - I too am now bleeding.
OC-3 - You sure got that right - it's a bastard to get that spring back in - 3 or 4 extra hands would be helpful.
IM_Lugger - I'm going to do just as you do, and not take it apart again to clean it.
Regards, DaveF.
.
 
You must log in or register to reply here.
Back
Top Bottom