norinco m305 question

W

willy87

New member
Rating - 100%
3   0   1
Location
Alberta
Hi guys. I just have a quick question. So i have a norinco m305 18.5" and there is a small retaining pin that holds the op rod spring guide to the reciever and is keeps backing out. Im just wondering if there is any quick fixes for this or if im doing somthing wrong?
 
It normally is not tight but held in place by the stock. There is one particular stock, I dont remember which one, where you have to glue a little piece of Popsicle stick to holt the pin in place.

What do you have, pics are best
 
This may sound to obvious but is the op rod spring guide installed properly and not backwards/upside down?
I assume the pin backs out when shot right?...... And the pin is the one that goes into the hole on the end of the op rod guide with the tiny arm sticking up for moving pin back and forth, I know this is it and obvious but want to be sure.
Probably wouldn't matter if it was in backwards/upside down but you never know, haven't done it.
 
Sorry i could give a little more info its a usgi synthetic stock and it backs out when im firing. I notice it when i swap mags because the guide sticks out. Im pretty sure its not upside down ile check when get home from work thanks guys
 
willy87 said:
Sorry i could give a little more info its a usgi synthetic stock and it backs out when im firing. I notice it when i swap mags because the guide sticks out. Im pretty sure its not upside down ile check when get home from work thanks guys
Click to expand...

yomomma said:
It normally is not tight but held in place by the stock. There is one particular stock, I dont remember which one, where you have to glue a little piece of Popsicle stick to holt the pin in place.

What do you have, pics are best
Click to expand...

Yup... yomomma & I guessed the same thing... And the solution is as he said, a little bit of popsicle stick...

Cheers
Jay
 
And willy87, now that we know you have a USGI stock... You need to do this... See pic... HE HE HE, my M14 in a USGI stock with a sparrowhawk dummy selector kit.

Cheers
Jay

image691.jpg
 
You no kidding the dummy selector switch looks sharp. I think this popsicle spacer trick should work percect.thanks for the help fellas i will report back on the fix when i get some time next week.
 
You must log in or register to reply here.
Back
Top Bottom