Norinko Sig 228 Copy Dissembly issues..Please Help

[punchdrunkkangaroo13]

Ok Girlfriend has a Norinko Copy of a Sig 228, we took it out to the range a while back and it stopped firing after a magazine... Couple of Click no bangs... we inspect ammo, no dimpling of rounds... check if the slide is going forward... yup still no dimpling of rounds, no light striking. Take it home and attempt to dissasemble it Dissembly lever rotates no problem... but slide will not advance off the frame, seems caught on something. I tried depressing the firing pin from the back to look for how far it will enter chamber area, it is probably the problem will not even get close to chamber now. But the problem is I think the little bit of pin has caught up some where and is binding the slide, Any ideas on how to fix this. I have dissasembled many a pistol to clean them or replace springs or ejectors but never had a problem like this with the slide binding and fireing pin breaking....

Any Help would be great, the norinko makes a nice paperweight right now but is kinda short for a club....

 

[Griffoneur]

If you purchased from Marstar, send it back and they will fix it.

 

[BEARMAN]

For a manual for the Sig 228 goto http://stevespages.com/page7b.htm and a schematic goto http://stevespages.com/page7a.htm There is a firing pin safety on the Sig design which prevents the firing pin from moving if the trigger is not pulled, if this part is damaged that MAY be your problem. But who knows? Good luck with the disassembly..

 

[(Ronin)]

Lock the slide back, pull the trigger,hit the slide release and it should go flying off

 

[nelly]

Ah, another satisfied Norinco customer...



Neal

 

[guess_kto]

Stupid question, but did you take the mag off?

1. Mag in, lock the slide
2. Move the lever down
3. Mag out
4. Release the slide and it should get off.

PS. Mag should have no ammo....

 

[banskopivo]

Hi Punchdrunk...

Any luck yet?