Nosler Accubond 6mm 90gr. load data

[scott_r]

I picked up a box of these and want to load some for whitetail and there is no data for it in my Nosler Reloading guide 6? Anyone know a good load to try? Im thinking Varget or IMR 4350??

Cheers!!

 

[Cleftwynd]

6mm Remington? I would start at about 42 grains of IMR 4350. What powders do you have on hand?

 

[scott_r]

sorry should have been more specific, its a .243. Id really like to try Varget. I will do some searching on Google and see what pops up.

 

[Eagleye]

IMR 4831. Start at 44 grains and work up carefully.
Eagleye.

 

[Big Jon]

I bet if you phone nosler you'll get some good advice.

 

[Cleftwynd]

I do not have any data here for Varget, but for RL19 start at 43, RL15 at 34, RL22 at 44, or IMR4350 at 41, or IMR 4895 at 35.

I have some info for other powders Like Hodgdon, or Viht... and the 90 grain, but nothing on Varget! I haven't ever used that powder yet....

 

[rojogrande]

For years I've used 42.5 grains of IMR4350 to send a 95 grain Hornady SST bullet out at 2,950 fps in my .243 Winchester.....CCI-200 primers and an R-P case......You can start at 41.0 grains of IMR4350 and work up in half grain increments......probably winding up near 43 grains as a max load by the time you're done.....

Curly

 

[bubba300]

Google Hodgdon and go to Reloading data center,there are lots of loads with Hodgdon.winchester and IMR loads there.My 243 likes Varget for the lighter bulletts and RL 22 for the heavier bulletts.
Good Luck