Nosler Brass

I've used it in .243. I like that it comes sized and weight sorted ready to load right from the box, but it is a bit pricey. I haven't reloaded this lot enough yet to know if it has a longer life or not, but the fact that it comes annealed as well can only add to it's longevity I imagine. So far so good after 4 reloads.

I have some on order for the .350 Remington Mag (it's new production this year, well...last year) so I won't have to rely on Remington's 'brass' for this caliber any longer. It has, however, been or order with Epps since August so I'm still just imagining trying it in the .350 at this point. :)
 
Only have heard good stuff about Nosler.

I have some 35Rem Hornady brass that is fresh factory ammo once fired but as yet not reloaded. I'm hoping it will be good.

I have some on order for the .350 Remington Mag (it's new production this year, well...last year) so I won't have to rely on Remington's 'brass' for this caliber any longer. It has, however, been or order with Epps since August ...
Click to expand...

Good luck getting that brass. You have more patience than me.

BTW as an aside, I form 350 RemMag if necessary from 338Win, 7mm Rem, or 300Win using one of these - a Redding 350 Remington Mag Form & Trim Die. Very handy item to have around if/when brass becomes scarce.

076-83266.jpg
 
Last edited:
woodlotowner said:
I have some on order for the .350 Remington Mag (it's new production this year, well...last year) so I won't have to rely on Remington's 'brass' for this caliber any longer. It has, however, been or order with Epps since August so I'm still just imagining trying it in the .350 at this point. :)
Click to expand...

Wow, that's a long wait and to say I saw some in stock at Cabela's in Winnipeg.
 
Time to call Epps and cancel my order. I too have seen them at Cabelas. Hmmm...

WhelenB, I do have a bunch of 7mm Rem Mag here that I could resize into .350 Rem Mag. Do you know where I could purchase such a die as the one in your post? Does it come with instructions...this will be a whole new process for me.

May have hijacked your thread a bit here, Bearhunter... :)
 
nosler brass

I use there brass for 2506, 2506AI, 280 AI,308,7M08.
I love it,everything is done for you,just prime and load.
Its pricey but well worth it.:D
 
just picked some up in 7mm-08, pricy but thought it would be worth a try. Really surprised with how they look and no dented necks ect, should be good.
 
WhelenB, I do have a bunch of 7mm Rem Mag here that I could resize into .350 Rem Mag. Do you know where I could purchase such a die as the one in your post? Does it come with instructions...this will be a whole new process for me.
Click to expand...

Don't want to hijack thread further - PM on its way.
 
You must log in or register to reply here.
Back
Top Bottom