- Location
- Southern Ontario
Has anyone isntalled the NY1 or NY2 trigger mod for a Glock 26 or 30? If so how complicated is it and what does it cost?
NY1 Trigger Glock 26/30
- Thread starter torontogunguy
- Start date
You want a heavier pull on your Glock? I've never installed a NY1 or NY2 trigger spring, but last time I checked they were about $3 USD. If you can do the most basic Glocksmithing (which is quite simple), it should take about 5 minutes. Just punch out the pins, lift out the locking block, then lift out the trigger assembly and swap in the NY spring.
- Location
- Southern Ontario
That's sorta what I thought. Thanks. Have you done any polishing while working on the trigger assembly?
This is what the stock trigger spring setup looks like
This is what it looks like with the NY1 trigger spring
This is what the part looks like...it costs about $3
If you add a 3.5# connector to the job it results in a better feeling trigger..they cost about $20..I have read that the factory Glock part is the most reliable
If you add the .25cent trigger job to the above two items, you get a nice smooth firearm
http://www.alpharubicon.com/mrpoyz/glock/
As a sidenote....
This is what it looks like with the NY1 trigger spring
This is what the part looks like...it costs about $3
If you add a 3.5# connector to the job it results in a better feeling trigger..they cost about $20..I have read that the factory Glock part is the most reliable
If you add the .25cent trigger job to the above two items, you get a nice smooth firearm
http://www.alpharubicon.com/mrpoyz/glock/
As a sidenote....
I've polished up the contact points while installing 3.5 connectors on about half a dozen Glocks now. It makes for a very nice trigger on new Glocks, but ones that have been shot a bunch tend to be naturally smoothed out already. And I did encounter a 1st gen. G17 with such a rough surface that all the metal polish in the world wouldn't have made any difference.
