Old CH Press

[the keepa]

Sorry diopter I replied to your message earlier but my message board was full so it wasn't sent .
I was in contact with Dave and he is gonna send me a toggle block and an extra sliding tool station .I will wait until I see if everything fits before I take you up on your generous offer

 

[diopter]

Just measured the the RCBS handle(which is still on the press, forgot I haven't replaced it when getting the Ergos for my Hornadys) that one is 5/8-18.

 

[the keepa]

May I suggest Welding a block of Metal drilled and tapped for 1/2-20 thread so you have some choices as to handles afterward? I have my original CH handle lying around doing nothing and a handle for my old RCBS rock chucker(have to check what thread that is). See my post #14 as to why. You can get them from me for the cost of postage.

I received my order from Dave today... the toggle and a sliding tool holder
The toggle is not threaded for a handle but I should be able to craft a handle .
But thanks for the offer