Older Ithaca 37's and Steel Shot-> Safe?
- Thread starter sixty9santa
- Start date
madtrapper143
CGN Ultra frequent flyer
- Location
- Steep Rock Lake NWO
I had an older 37. I had a smith open the full choke to modified. It worked well until I fired steel #1 shot in the gun. You could see pellet imprints in the forcing cone. It seems that steel no larger than #2 works fine with it's flow characteristics. #1 was just too big. Other than that no problems.
cheers Darryl
cheers Darryl
the older ithaca 37's can handle steel under full choke,maybe even a wee bit less than mod.i shoot a 37 DOM 1948, but i don't use anything larger than 3's.the smaller shot sizes are much easier on the barrel and they pattern substantially better.
Steel Shot Alterations
Forcing Cone Alteration:
Factory shotgun barrels usually have a fairly short and abrupt forcing cone. The forcing cone is the tapered area just ahead of the chamber where the shell is contained. Altering the forcing cone, so it is one and one half or two inches in length, reduces recoil and improves the pattern density. Trap shooters and skeet shooters have been doing this for many years. It is a good benefit to the steel shot user as well.
Choke Alteration:
Choke designation from the tightest to the most open are:
Extra Full, Full, Improved Modified, Modified, Skeet II, Improved Cylinder, Skeet I, and Cylinder Bore.
Steel shot does not require the constriction that lead shot needs, to produce good patterns. In fact too much constriction, causes poor, erratic patterns, and in some cases, permanently damages the barrel. I have seen barrels bulged at the choke, I have seen barrels where the choke split right open, from using steel shot.
For steel shot, with thin barrels, chokes should be altered to at least Skeet II. Often, over & under, and side-by-side shotguns, are best altered to Skeet I and Skeet II chokes. Heavier barrels can be left at Modified choke but may see an improvement in the pattern if opened slightly.
Forcing Cone Alteration:
Factory shotgun barrels usually have a fairly short and abrupt forcing cone. The forcing cone is the tapered area just ahead of the chamber where the shell is contained. Altering the forcing cone, so it is one and one half or two inches in length, reduces recoil and improves the pattern density. Trap shooters and skeet shooters have been doing this for many years. It is a good benefit to the steel shot user as well.
Choke Alteration:
Choke designation from the tightest to the most open are:
Extra Full, Full, Improved Modified, Modified, Skeet II, Improved Cylinder, Skeet I, and Cylinder Bore.
Steel shot does not require the constriction that lead shot needs, to produce good patterns. In fact too much constriction, causes poor, erratic patterns, and in some cases, permanently damages the barrel. I have seen barrels bulged at the choke, I have seen barrels where the choke split right open, from using steel shot.
For steel shot, with thin barrels, chokes should be altered to at least Skeet II. Often, over & under, and side-by-side shotguns, are best altered to Skeet I and Skeet II chokes. Heavier barrels can be left at Modified choke but may see an improvement in the pattern if opened slightly.
