Omega 6, officially off the fence(pic heavy page 5)

[Max Renegade]

Range trip today, about 130 rounds only had 3 that needed coaxing to feed up the ramp and 2 that jammed straight forward into the ramp and had to drop the mag to fix (1 of the 2 the projectile compressed into the brass) most of the problems are with the first round today only had 1 mid mag jam. I was using the factory mag and a 45 act mag.

All in all though it felt like an improvement less frequent jams, and seems like the factory spring is breaking in nicely at least the ejecting brass is not bouncing off the roof anymore

 

[Max Renegade]

Just a though... Has anyone looked into the cost and effort to convert it to 9mm?

 

[heavenIsAlie]

you would need to have a while new top end built by a smith

 

[Max Renegade]

Cant just buy a barrel for the omega 6 9mm and a spring eh... I guess that be too easy.

 

[dallasm]

Breech face in the slide is .40/10mm. You can convert it from 40S&W to 10mm with barrel, spring and mag. 9mm would take a new slide as was mentioned above.

 

[Hitzy]

Got out today after a couple new mods. Gave the feed ramp a good polish, had a new custom cut bushing from EGW installed, zero jams of any kind through the 200 rounds, 180gr UMC shot point of aim and grouped really nice, 165gr Centaur shot a little high but burnt clean and seems like pretty decent ammo for commercial reloads.