Out law shotgun

C

cdm123

CGN frequent flyer
First thanks for the free gun :d now the bad news, hopefully an easy fix. So I clean all the packing oil off and assemble clean the bore etc. and notice I can't move the safety. Then #### the hammer and try pulling triggers sure nuff they drop but stop short of contacting firing pins any suggestions?
 
Last edited:
I would suggest more cleaning. Varsol and compressed air to get all the gunk out of the firing pin chanels.
 
cdm123 said:
First thanks for the free gun :d now the bad news, hopefully an easy fix. So I clean all the packing oil off and assemble clean the bore etc. and notice I can't move the safety. Then #### the hammer and try pulling triggers sure nuff they drop but stop short of contacting firing pins any suggestions?
Click to expand...

when i got mine I couldn't move the safety either it was really stiff, in fact everything was stiff. After a trip to the range, that shotgun feels right, now its easy to open and close the shotgun and safety works well. I thought also that the hammer weren't hitting the firing pin at first when I got it but if you pay attention (or film in slow-mo lol) they do hit and then go back to their positions.
 
its a safety that the hammers dont rest on the firing pin. hold the triggers and push the hammers forward and you will see the pin poke out. If you are adventurous you can put your finger over the hole on the breech and drop the hammer ;)
 
Thanks for all the reply's, I will spray more break leaner on it and take it for a test firing.
 
You must log in or register to reply here.
Back
Top Bottom