P226 LDC or CZ Shadow 2
- Thread starter Sniffer
- Start date
Please bear in mind I am referring to the type of adjustment made with a screw dial - after researching this a little more it seems the CZ Shadow 2 does have an elevation screw for adjustment and can be adjusted for windage by slackening the sight and sliding it over slightly (taken straight from the Shadow 2 manual):
This is a picture of the P226 LDC which suggests is has dials for both Windage and Elevation:
Attachments
I have owned 3 sig p226's, DAK in .40, MK25 9mm and now the blackwater in 9mm. I kept the backwater, sigs are very nice.
But I have to admit, I prefer my shadow 2. The trigger, feel and controls are better for me. I'd say try either, you can't go wrong.. but if you're looking for a deal on a shadow 2 gotenda has them on for 1199 with free shipping.
But I have to admit, I prefer my shadow 2. The trigger, feel and controls are better for me. I'd say try either, you can't go wrong.. but if you're looking for a deal on a shadow 2 gotenda has them on for 1199 with free shipping.
Anyone know the trigger pull weights on the pistols in question?
SIG P226 LDC
CZ Shadow 2
SIG P226 Legion SAO
I`ve had a look around on the net but getting a bunch of different values so don't know what to believe
SIG P226 LDC
CZ Shadow 2
SIG P226 Legion SAO
I`ve had a look around on the net but getting a bunch of different values so don't know what to believe
Trigger pull on the P226 (LDC and Legion or any 226) is 10lbs in DA and 4.4lbs in SA. This can be reduced with a reduce power mainspring. I can't recall which weight mainspring (18lbs sounds familiar) I installed but it dropped my DA to around 9lb and SA to 3.5lbs. I tried a lighter spring but had light primer strikes. Turns out I'll have to install a reduced power firing pin spring as well but I'm waiting to do that when next I disassemble my slide as I'm supposed to use a new roll pin after removing the current one. Just got another 3.5K rounds to go.
Trigger pull on the S2 is 10lbs in DA and 3.5lbs in SA. This can be reduced with a reduce power mainspring. I'm currently sitting at 7.5lbs DA and right at 2lbs in SA.
I'm running a 10lb mainspring along with a reduced power firing pin spring. So far 100% strikes on CCI, Dominion and S&B primers. I did a full strip and polished up the parts and that shaved a 1/4lb off SA. Accuracy in DA improved greatly indeed esp if on the clock. I wasn't doing too bad stock DA but just took a much longer time with a really deliberate s-l-o-w squeeze. I don't want to go anywhere less than 2lbs SA trigger.
Sounds like a nice setup
So where did you get the parts (10lb spring etc)?
And does anyone know if its possible to get a flat trigger for the DA/SA Shadows? I`ve taken a real shine to them recently after installing one in my P320
Got my parts from ipscstore.eu. As far as I know those flat triggers are only SAO.
Wolverine sells a flat hooked SA Tactical Sport trigger, I ordered one, should arrive today.
Installing in a shadow 2, cant remember which site I seen it on....mabey the CZ site that lists the Shadow 2, TS, SP01 etc etc as using the same trigger.
