Yet another "Load for my M14/305" question...but I hope better.
Its accepted that the Norcs have a long headspace, thus reducing case life when FL sized. But would there be a way to FL size your cases without bumping back the shoulder each time?
I guess the better way to put it would be: how do I make sure I am seating the die far enough to fully size the case, but not so deep that it pushes the shoulder back?
Its accepted that the Norcs have a long headspace, thus reducing case life when FL sized. But would there be a way to FL size your cases without bumping back the shoulder each time?
I guess the better way to put it would be: how do I make sure I am seating the die far enough to fully size the case, but not so deep that it pushes the shoulder back?