Pet loads for 9.3 x 62

[338 Imperial]

Lookin' to see if any of you have some pet loads for the 9.3x62 you are willing to share .
I have a large variety of projectiles & quite a few powders that should be suitable to choose from.
Just looking for reliable accurate loads , velocity isn't my goal.
PM me if you are reluctant to post your data , I get it .
thanks all...happy shooting !
Ed

 

[65cutlass]

290 gr. Matrix ballistics w/ 55 gr. Varget works well in my 20"CZ550 9.3x62. Yours may require a different load.

 

[65cutlass]

The above load worked well on a Bison, and a different time a Moose.

 

[Johnn Peterson]

The above load worked well on a Bison, and a different time a Moose.

When I decided to get a 9.3x62, aka .366 Wagner, I went the 'inexpensive' route and picked up a full wood M-70 Zastava. I've posted much of this in past, but in preparation I accumulated a selection of components I planned to test. Some of the first, was a quantity of Lapua unprimed brass and a quantity of 285gr PRVI bullets. Have a 'decent' amount of IMR 4320 and IMR 4064. So, using the data for those powders along with the 286gr bullet as listed in the Nosler 5th edition manual, is where I began. Considering the Zastava quality, the accuracy I got with the first few tests of their mid to top end loads was EXCEPTIONAL. I was amazed to the point that I never bothered testing any further.
I purchased the rifle from Trade Ex. Most recently, again with the success using the 285gr PRVI, I've 'stocked' up my supply of those 285gr PRVI bullets, again, from Trade Ex.
When the Matrix producer was located close by in Crofton, I paid him and his operation a visit at which time I purchased some of his 9.3 bullets. As I've decided to stick with the 285gr PRVI, I traded off the Matrix to a gentleman from Whitehorse.

 

[9.3mauser]

Reloader 15- 58.5 produces 2,350 with a 285 gr bullet, 60 grs goes up to 2,480.
62 gr with a 250 gr Accubond runs at 2,625.

No pressure signs in my rifle.

 

[freire]

My load consists of cci 200 primers, Prvi brass and 285gr Prvi bullet powered 59.5gr of Varget.
I have excellent accuracy with it in my rifle

 

[mimile]

PRVI 286, Fed210LR, H4895 57 grains, Lapua or PPU brass, Velocity 2440 FPS and sub moa in a Zastava M70.

 

[mimile]

Most recently, again with the success using the 285gr PRVI, I've 'stocked' up my supply of those 285gr PRVI bullets, again, from Trade Ex.

So you are the one who cleaned them up? LOL.

 

[Johnn Peterson]

Most recently, again with the success using the 285gr PRVI, I've 'stocked' up my supply of those 285gr PRVI bullets, again, from Trade Ex.

So you are the one who cleaned them up? LOL.

With Trade Ex scaling down, I thought I'd best get while the getting was good.

 

[338 Imperial]

Thanks for all the reply's .
I do not have PRVI or Matrix
I do have Barnes , Hornady, Nosler , Tug,Speer , & some hard cast.
Let the development begin !

 

[Andy]

A lightly compressed load of Reloder 17 works very well with the 285 gr Prvi bullet.

 

[uberti77]

Moose load:
Hornady 9.3x62 case
Primer Remington LR 9 1/2
Bullet Norma Oryx 325 gr.
Powder Norma 202 for 52gr.
Speed at muzzle : 2150 fps
Rifle: ruger Hawkeye safari
My precision: 1 1/4" moa

Note: Norma oryx , fantastic weight retention for a lead bullet. Very very bonded

 

[uberti77]

Hornady 9.3x62 case
Powder D4064 for 48gr.
Bullet barnes tsx 286gr.
Primer cci large rifle #200
Speed at muzzle 2200 fps
Rifle : ruger hawkeye 23"
My precision: 2 moa

Note: one might wanna consider lighter bullets for more powder space and speed. Consider 250gr. Hornady GMX...