polytech stock question

[chalkriver]

I have a polytech synthetic stock off my 2009 for sale on the E.E , does anyone know if this will fit the earlier 2007 norc receivers ? I thought I read somewhere that it does but it is atight fit .

Thanks

 

[Dsiwy]

I cant see why not

 

[asphalt599]

Shouod fit. I can't see that there would be enough differenct to cause a problem.

 

[Satain]

There are only 3 things on the new stock that might cause you grief.

1. The area were the trigger pads contact although very rarley occur are not deep enough or to deep in some cases.
2. Some times it been reported that at the front of the stock there is to much plastic before ferrule that causes issues. Ask the Doc about this more.
3. Bedding the action can be finicky to do becuase plastic dosn't play nice with most bedding materails.

Other than that you should be good 2 go!

 

[chalkriver]

Ok thanks for the replies , I read an old reveiw by Hungry and he said it was tight by the front mortices and some grinding of the stock liner was necessary .

I have someone interested in my stock and dont want to give him problems..

Anyone here done the swap??

 

[asphalt599]

Just make sure he is aware there might be a litttle bit of fine tuning. Should be good to go.

 

[shootemup]

A file is your friend. Doesn't take much at all.

 

[chalkriver]

Ok Thanks for the info ..but the OP has decided on a USGI instead....good choice as that is what I swapped my poly stock for .

Good to know

Thanks