Power Case Preping

R

Ronnie3

Member
Rating - 100%
16   0   0
Anyone know where I can get an a unit ( pieces, kit, or whatever ) so I can use a drill press to turn case necks and trim lengths ? I know they make case trimmers with a small electric motor to run them, but I would perfer to use a drill press, someone out there must be using a set up like this.
Info appreciated.
Ron
 
I took an old drill press and removed the stand so it now sits on the top cover with the chuck facing up, and used the Lee trimmers in it. I like it cuz it's cheap enough to get all the calibers you need, and while it's spinning you can chamfer the brass. Not as fast as the other powered trimmers but it works and is cost effective.

Got all the stuff from higginsons powder outside of ottawa.

Hope that's a start,

J
 
Thanks for the info, the forester one looks interesting but I'm not sure if theres an adapter to allow me the turn the necks, oh well, maybe I'll have to become creative :) .
Thanks, Ron
 
You must log in or register to reply here.
Back
Top Bottom