PREORDER for KAC Style 18.6 Dimpled Match AR15 Barrels

The rifle length is softer shooting and almost all top notch 3 gun guys prefers rifle length gas.
your dimpled barrel 18.6 + rifle length gas would be a very nice setup.
 
Last edited:
Familygunnutz said:
The rifle length is softer shooting and almost all top notch 3 gun guys prefers rifle length gasport,
your dimpled barrel 18.6 + rifle length gas would be a very nice setup.
Click to expand...

Thanks for the feed back, this is something we can look at on the next run, if we do them, we have been running a Mid lenght on a 14.5 16.1 and am 18.2 for about 5yrs now, i do like the balance, but we just them mostly as carbines, not full size rifles, but again somthign we can look at for sure on the next run.
At this point i think we will be sold out of this run by next week .
 
Could these be made available without the gas block and gas tube. Id like to put an Adams Arms piston system on my gun but use this barrel. LMK if that an option or if it would even work they way im thinking. Ill place an order right away if it is possible.
 
I asked this in the other thread but I'll ask here as it seems to be getting more action:

Is it possible you will do a pinned gas block on future runs or is it possible to pay a little more to have it done by you on this run?
 
juancarlos said:
I asked this in the other thread but I'll ask here as it seems to be getting more action:

Is it possible you will do a pinned gas block on future runs or is it possible to pay a little more to have it done by you on this run?
Click to expand...

this is something ill , ask my gun smith do, as it will requite us to make an jig and index each gas block and and of course drill the gas block and barrel at the same time. and pin it
this is normally something i would only do when building a gun.
The other issue may be getting a taper pin small enough as out gas blocks are very low profile.
would you be happy with a straight pin not a taper pin?
 
we are tryign to get back to everyone as fast as we can

we have 5 left on the pre order of the 18.6 and 9 left on the 14.5
its all we have time and materiel to to work with on this run.
as we have other projects we have to keep up with.
BBB
 
Id like to be on the pre-order, but only if I can get the barrel without the gas block. Or at least verify the gasblock is removeable. Ill probably just put my order in anyway and see what happens.
 
badboybeeson said:
this is something ill , ask my gun smith do, as it will requite us to make an jig and index each gas block and and of course drill the gas block and barrel at the same time. and pin it
this is normally something i would only do when building a gun.
The other issue may be getting a taper pin small enough as out gas blocks are very low profile.
would you be happy with a straight pin not a taper pin?
Click to expand...

Yes, straight pin is perfect.
 
You must log in or register to reply here.
Back
Top Bottom