Stupid Tenda and their flash sale....I now have a bullet feeder on the way. New problem is loading those pesky little primers. I’ve looked at the Frankford handheld one and the hornady one. Are there any others that are any good? For what I’ve seen them listed at hoping to find one for $70 or less just wondering if there is a better option out there or if this is about it. Thanks.
Primer loaders....what to buy.
- Thread starter sookie_69
- Start date
- Location
- West Quebec
I have the Frankford unit and it worked well after I took some of the small rough edges of in the plastic area near the loading gate
Here is a link that may help.. https://www.youtube.com/watch?v=r0layqAVnwE
Here is a link that may help.. https://www.youtube.com/watch?v=r0layqAVnwE
- Location
- West Quebec
I use a rubber coupler to join the Dillon primer tubes to the Vibra Prime after loading and they zip right into the Dillon tubes.
- Location
- West Quebec
They did not seem to fit the model I have so that's what I came up with
- Location
- West Quebec
I dropped more than I loaded LOL
- Location
- West Quebec
My model has a big plastic wingnut that secures into the housing so putting in the dillon rods don't work very well maybe we have different models mine may be an older model
- Location
- West Quebec
Looks the same my adapter seems to be permanently welded in place I'd be afraid to pull it off without breaking it..
I'll give it a try thanks for the insight..
I'll give it a try thanks for the insight..
I have the Hornady 1911 one and it works awesome. Only issue was small Winchester seemed to get hung up. Took a razor knife and just went around the hole going into the tube. I couldn’t see anything but it worked and I have had zero issues with different large or small primers. I will never peck primers again.
Only one better is the $500 Dillon
Only one better is the $500 Dillon
